iio: magnetometer: yas530: Change data type of calibration coefficients

iio: magnetometer: yas530: Change data type of calibration coefficients

This is a preparation for adding YAS537 variant.

YAS537 uses other data types on the calibration coefficients [1] than YAS530 [2]
and YAS532 [3].

On YAS537, at least for a4 and a7 this could matter because 8-bit unsigned data
from the register gets stored into a signed data type, therefore this should be
8-bit as well.

For YAS530/532, on the other hand, it doesn't seem to matter. The size of a2-a9
and k is smaller than 8-bit at extraction, also the applied math is low. And
Cx/Cy1/Cy2, now being defined as signed 16-bit, are extracted as unsigned 8-bit
and undergo only minor math.

[1] https://github.com/msm8916-mainline/android_kernel_qcom_msm8916/blob/GT-I9195I/drivers/iio/magnetometer/yas_mag_drv-yas537.c#L76-L78
[2] https://github.com/NovaFusion/android_kernel_samsung_golden/blob/cm-12.1/drivers/sensor/compass/yas_mag_driver-yas530.c#L526-L527
[3] https://github.com/msm8916-mainline/android_kernel_qcom_msm8916/blob/GT-I9195I/drivers/iio/magnetometer/yas_mag_drv-yas532.c#L76-L77

Signed-off-by: Jakob Hauser <jahau@rocketmail.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>
Link: https://lore.kernel.org/r/f1e53bd6672aebe59f9b236b41374482edf888f8.1660337264.git.jahau@rocketmail.com
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>