wifi: ath12k: scan statemachine changes for single wiphy

wifi: ath12k: scan statemachine changes for single wiphy

When multiple radios are advertised as a single wiphy which
supports various bands, a default scan request to mac80211
from cfg80211 will split the driver request based on band,
so each request will have channels belonging to the same band.
With this supported by default, the ath12k driver on receiving
this request checks for one of the channels in the request and
selects the corresponding radio(ar) on which the scan is going
to be performed and creates a vdev on that radio.

Note that on scan completion this vdev is not deleted. If a new
scan request is seen on that same vif for a different band the
vdev will be deleted and created on the new radio supporting the
request. The vdev delete logic is refactored to have this done
dynamically.

The reason for not deleting the vdev on scan stop is to avoid
repeated delete-create sequence if the scan is on the same band.
Also, during channel assign, new vdev creation can be optimized
as well.

Also if the scan is requested when the vdev is in started state,
no switching to new radio is allowed and scan on channels only
within same radio is allowed.

Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3

Signed-off-by: Sriram R <quic_srirrama@quicinc.com>
Co-developed-by: Rameshkumar Sundaram <quic_ramess@quicinc.com>
Signed-off-by: Rameshkumar Sundaram <quic_ramess@quicinc.com>
Signed-off-by: Kalle Valo <quic_kvalo@quicinc.com>
Link: https://msgid.link/20240405194519.1337906-6-quic_ramess@quicinc.com