RDMA/mlx5: Allow relaxed ordering read in VFs and VMs

RDMA/mlx5: Allow relaxed ordering read in VFs and VMs

According to PCIe spec, Enable Relaxed Ordering value in the VF's PCI
config space is wired to 0 and PF relaxed ordering (RO) setting should
be applied to the VF. In QEMU (and maybe others), when assigning VFs,
the RO bit in PCI config space is not emulated properly and is always
set to 0.

Therefore, pcie_relaxed_ordering_enabled() always returns 0 for VFs and
VMs and thus MKeys can't be created with RO read even if the PF supports
it.

pcie_relaxed_ordering_enabled() check was added to avoid a syndrome when
creating a MKey with relaxed ordering (RO) enabled when the driver's
relaxed_ordering_read_pci_enabled HCA capability is out of sync with FW.
With the new relaxed_ordering_read capability this can't happen, as it's
set regardless of RO value in PCI config space and thus can't change
during runtime.

Hence, to allow RO read in VFs and VMs, use the new HCA capability
relaxed_ordering_read without checking pcie_relaxed_ordering_enabled().
The old capability checks are kept for backward compatibility with older
FWs.

Allowing RO in VFs and VMs is valuable since it can greatly improve
performance on some setups. For example, testing throughput of a VF on
an AMD EPYC 7763 and ConnectX-6 Dx setup showed roughly 60% performance
improvement.

Signed-off-by: Avihai Horon <avihaih@nvidia.com>
Reviewed-by: Shay Drory <shayd@nvidia.com>
Reviewed-by: Aya Levin <ayal@nvidia.com>
Link: https://lore.kernel.org/r/e7048640d66c341a8fa0465e099926e7989184bc.1681131553.git.leon@kernel.org
Reviewed-by: Jacob Keller <jacob.e.keller@intel.com>
Signed-off-by: Leon Romanovsky <leon@kernel.org>