Get the firmware reset status address from the dynamic registers
we read from the firmware instead of using a define.
Signed-off-by: farah kassabri <fkassabri@habana.ai>
Reviewed-by: Oded Gabbay <ogabbay@kernel.org>
Signed-off-by: Oded Gabbay <ogabbay@kernel.org>
 
        if (!driver_performs_reset) {
                /* set SP to indicate reset request sent to FW */
-               WREG32(mmCPU_RST_STATUS_TO_HOST, CPU_RST_STATUS_NA);
+               if (dyn_regs->cpu_rst_status)
+                       WREG32(le32_to_cpu(dyn_regs->cpu_rst_status), CPU_RST_STATUS_NA);
+               else
+                       WREG32(mmCPU_RST_STATUS_TO_HOST, CPU_RST_STATUS_NA);
 
                WREG32(le32_to_cpu(dyn_regs->gic_host_soft_rst_irq),
                        gaudi2_irq_map_table[GAUDI2_EVENT_CPU_SOFT_RESET].cpu_id);
 
        __le32 gic_host_ints_irq;
        __le32 gic_host_soft_rst_irq;
        __le32 gic_rot_qm_irq_ctrl;
-       __le32 reserved1[22];           /* reserve for future use */
+       __le32 cpu_rst_status;
+       __le32 eng_arc_irq_ctrl;
+       __le32 reserved1[20];           /* reserve for future use */
 };
 
 /* TODO: remove the desc magic after the code is updated to use message */