arm64: dts: ti: k3-am65: MDIO pinmux should belong to the MDIO node

Although usually integrated as a child of an Ethernet controller, MDIO
IP has an independent pinout. This pinout should be controlled by
the MDIO node (so if it was to be disabled for instance, the pinmux
state would reflect that).

Move the MDIO pins pinmux to the MIDO nodes.

Signed-off-by: Andrew Davis <afd@ti.com>
Signed-off-by: Nishanth Menon <nm@ti.com>
Tested-by: Jan Kiszka <jan.kiszka@siemens.com>
Reviewed-by: Bryan Brattlof <bb@ti.com>
Link: https://lore.kernel.org/r/20221028142417.10642-7-afd@ti.com

diff --git a/arch/arm64/boot/dts/ti/k3-am654-base-board.dts b/arch/arm64/boot/dts/ti/k3-am654-base-board.dts
index f4b8747ebaef62673ff252ffa56e64ba38be5ae6..0c63c24941061501e59957a7a06dfe502bbcbff1 100644 (file)
--- a/arch/arm64/boot/dts/ti/k3-am654-base-board.dts
+++ b/arch/arm64/boot/dts/ti/k3-am654-base-board.dts
@@ -529,10 +529,13 @@
 
 &mcu_cpsw {
        pinctrl-names = "default";
-       pinctrl-0 = <&mcu_cpsw_pins_default &mcu_mdio_pins_default>;
+       pinctrl-0 = <&mcu_cpsw_pins_default>;
 };
 
 &davinci_mdio {
+       pinctrl-names = "default";
+       pinctrl-0 = <&mcu_mdio_pins_default>;
+
        phy0: ethernet-phy@0 {
                reg = <0>;
                ti,rx-internal-delay = <DP83867_RGMIIDCTL_2_00_NS>;