arm64: dts: mediatek: asurada: Enable MMC

Enable both MMC controllers present on Asurada. MMC0 is for
non-removable internal memory, while MMC1 is an SD card slot. MMC1 isn't
used on all machines, but in those cases the CD interrupt is never
triggered and thus it is basically as if it was disabled.

Signed-off-by: Nícolas F. R. A. Prado <nfraprado@collabora.com>
Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>
Tested-by: Chen-Yu Tsai <wenst@chromium.org>
Link: https://lore.kernel.org/r/20220629155956.1138955-18-nfraprado@collabora.com
Signed-off-by: Matthias Brugger <matthias.bgg@gmail.com>

diff --git a/arch/arm64/boot/dts/mediatek/mt8192-asurada.dtsi b/arch/arm64/boot/dts/mediatek/mt8192-asurada.dtsi
index d56c73e3763308a9d0f9ba60ddb3e6b7ec6a1071..7b89f6e552c5dd72e03925045589500069e6537a 100644 (file)
--- a/arch/arm64/boot/dts/mediatek/mt8192-asurada.dtsi
+++ b/arch/arm64/boot/dts/mediatek/mt8192-asurada.dtsi
@@ -170,6 +170,46 @@
        pinctrl-0 = <&i2c7_pins>;
 };
 
+&mmc0 {
+       status = "okay";
+
+       pinctrl-names = "default", "state_uhs";
+       pinctrl-0 = <&mmc0_default_pins>;
+       pinctrl-1 = <&mmc0_uhs_pins>;
+       bus-width = <8>;
+       max-frequency = <200000000>;
+       vmmc-supply = <&mt6359_vemc_1_ldo_reg>;
+       vqmmc-supply = <&mt6359_vufs_ldo_reg>;
+       cap-mmc-highspeed;
+       mmc-hs200-1_8v;
+       mmc-hs400-1_8v;
+       supports-cqe;
+       cap-mmc-hw-reset;
+       mmc-hs400-enhanced-strobe;
+       hs400-ds-delay = <0x12814>;
+       no-sdio;
+       no-sd;
+       non-removable;
+};
+
+&mmc1 {
+       status = "okay";
+
+       pinctrl-names = "default", "state_uhs";
+       pinctrl-0 = <&mmc1_default_pins>;
+       pinctrl-1 = <&mmc1_uhs_pins>;
+       bus-width = <4>;
+       max-frequency = <200000000>;
+       cd-gpios = <&pio 17 GPIO_ACTIVE_LOW>;
+       vmmc-supply = <&mt6360_ldo5_reg>;
+       vqmmc-supply = <&mt6360_ldo3_reg>;
+       cap-sd-highspeed;
+       sd-uhs-sdr50;
+       sd-uhs-sdr104;
+       no-sdio;
+       no-mmc;
+};
+
 /* for CORE */
 &mt6359_vgpu11_buck_reg {
        regulator-always-on;
@@ -503,6 +543,115 @@
                };
        };
 
+       mmc0_default_pins: mmc0-default-pins {
+               pins-cmd-dat {
+                       pinmux = <PINMUX_GPIO184__FUNC_MSDC0_DAT0>,
+                                <PINMUX_GPIO188__FUNC_MSDC0_DAT1>,
+                                <PINMUX_GPIO185__FUNC_MSDC0_DAT2>,
+                                <PINMUX_GPIO193__FUNC_MSDC0_DAT3>,
+                                <PINMUX_GPIO186__FUNC_MSDC0_DAT4>,
+                                <PINMUX_GPIO189__FUNC_MSDC0_DAT5>,
+                                <PINMUX_GPIO187__FUNC_MSDC0_DAT6>,
+                                <PINMUX_GPIO190__FUNC_MSDC0_DAT7>,
+                                <PINMUX_GPIO183__FUNC_MSDC0_CMD>;
+                       input-enable;
+                       drive-strength = <8>;
+                       bias-pull-up = <MTK_PUPD_SET_R1R0_01>;
+               };
+
+               pins-clk {
+                       pinmux = <PINMUX_GPIO192__FUNC_MSDC0_CLK>;
+                       drive-strength = <8>;
+                       bias-pull-down = <MTK_PUPD_SET_R1R0_10>;
+               };
+
+               pins-rst {
+                       pinmux = <PINMUX_GPIO194__FUNC_MSDC0_RSTB>;
+                       drive-strength = <8>;
+                       bias-pull-down = <MTK_PUPD_SET_R1R0_01>;
+               };
+       };
+
+       mmc0_uhs_pins: mmc0-uhs-pins {
+               pins-cmd-dat {
+                       pinmux = <PINMUX_GPIO184__FUNC_MSDC0_DAT0>,
+                                <PINMUX_GPIO188__FUNC_MSDC0_DAT1>,
+                                <PINMUX_GPIO185__FUNC_MSDC0_DAT2>,
+                                <PINMUX_GPIO193__FUNC_MSDC0_DAT3>,
+                                <PINMUX_GPIO186__FUNC_MSDC0_DAT4>,
+                                <PINMUX_GPIO189__FUNC_MSDC0_DAT5>,
+                                <PINMUX_GPIO187__FUNC_MSDC0_DAT6>,
+                                <PINMUX_GPIO190__FUNC_MSDC0_DAT7>,
+                                <PINMUX_GPIO183__FUNC_MSDC0_CMD>;
+                       input-enable;
+                       drive-strength = <10>;
+                       bias-pull-up = <MTK_PUPD_SET_R1R0_01>;
+               };
+
+               pins-clk {
+                       pinmux = <PINMUX_GPIO192__FUNC_MSDC0_CLK>;
+                       drive-strength = <10>;
+                       bias-pull-down = <MTK_PUPD_SET_R1R0_10>;
+               };
+
+               pins-rst {
+                       pinmux = <PINMUX_GPIO194__FUNC_MSDC0_RSTB>;
+                       drive-strength = <8>;
+                       bias-pull-down = <MTK_PUPD_SET_R1R0_01>;
+               };
+
+               pins-ds {
+                       pinmux = <PINMUX_GPIO191__FUNC_MSDC0_DSL>;
+                       drive-strength = <10>;
+                       bias-pull-down = <MTK_PUPD_SET_R1R0_10>;
+               };
+       };
+
+       mmc1_default_pins: mmc1-default-pins {
+               pins-cmd-dat {
+                       pinmux = <PINMUX_GPIO54__FUNC_MSDC1_DAT0>,
+                                <PINMUX_GPIO56__FUNC_MSDC1_DAT1>,
+                                <PINMUX_GPIO55__FUNC_MSDC1_DAT2>,
+                                <PINMUX_GPIO53__FUNC_MSDC1_DAT3>,
+                                <PINMUX_GPIO52__FUNC_MSDC1_CMD>;
+                       input-enable;
+                       drive-strength = <8>;
+                       bias-pull-up = <MTK_PUPD_SET_R1R0_01>;
+               };
+
+               pins-clk {
+                       pinmux = <PINMUX_GPIO51__FUNC_MSDC1_CLK>;
+                       drive-strength = <8>;
+                       bias-pull-down = <MTK_PUPD_SET_R1R0_10>;
+               };
+
+               pins-insert {
+                       pinmux = <PINMUX_GPIO17__FUNC_GPIO17>;
+                       input-enable;
+                       bias-pull-up;
+               };
+       };
+
+       mmc1_uhs_pins: mmc1-uhs-pins {
+               pins-cmd-dat {
+                       pinmux = <PINMUX_GPIO54__FUNC_MSDC1_DAT0>,
+                                <PINMUX_GPIO56__FUNC_MSDC1_DAT1>,
+                                <PINMUX_GPIO55__FUNC_MSDC1_DAT2>,
+                                <PINMUX_GPIO53__FUNC_MSDC1_DAT3>,
+                                <PINMUX_GPIO52__FUNC_MSDC1_CMD>;
+                       input-enable;
+                       drive-strength = <8>;
+                       bias-pull-up = <MTK_PUPD_SET_R1R0_01>;
+               };
+
+               pins-clk {
+                       pinmux = <PINMUX_GPIO51__FUNC_MSDC1_CLK>;
+                       input-enable;
+                       drive-strength = <8>;
+                       bias-pull-down = <MTK_PUPD_SET_R1R0_10>;
+               };
+       };
+
        pcie_pins: pcie-default-pins {
                pins-pcie-wake {
                        pinmux = <PINMUX_GPIO63__FUNC_PCIE_WAKE_N>;