media: Documentation: LP-11 and LP-111 are states, not modes

LP-11 and LP-111 are CSI-2 bus states, not modes. Fix this.

Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl>

diff --git a/Documentation/driver-api/media/tx-rx.rst b/Documentation/driver-api/media/tx-rx.rst
index 7c70b9d106346ac0baaedda1489a73e3cb07c4ee..29d66a47b56e95ef707335eeff73f3445ff84c38 100644 (file)
--- a/Documentation/driver-api/media/tx-rx.rst
+++ b/Documentation/driver-api/media/tx-rx.rst
@@ -91,8 +91,8 @@ where
        pixel rate on the camera sensor's pixel array which is indicated by the
        :ref:`V4L2_CID_PIXEL_RATE <v4l2-cid-pixel-rate>` control.
 
-LP-11 and LP-111 modes
-^^^^^^^^^^^^^^^^^^^^^^
+LP-11 and LP-111 states
+^^^^^^^^^^^^^^^^^^^^^^^
 
 As part of transitioning to high speed mode, a CSI-2 transmitter typically
 briefly sets the bus to LP-11 or LP-111 state, depending on the PHY. This period
@@ -106,7 +106,7 @@ in software, especially when there is no interrupt telling something is
 happening.
 
 One way to address this is to configure the transmitter side explicitly to LP-11
-or LP-111 mode, which requires support from the transmitter hardware. This is
+or LP-111 state, which requires support from the transmitter hardware. This is
 not universally available. Many devices return to this state once streaming is
 stopped while the state after power-on is LP-00 or LP-000.
 
@@ -117,11 +117,11 @@ transitioning to streaming state, but not yet start streaming. Similarly, the
 to call ``.post_streamoff()`` for each successful call of ``.pre_streamon()``.
 
 In the context of CSI-2, the ``.pre_streamon()`` callback is used to transition
-the transmitter to the LP-11 or LP-111 mode. This also requires powering on the
+the transmitter to the LP-11 or LP-111 state. This also requires powering on the
 device, so this should be only done when it is needed.
 
-Receiver drivers that do not need explicit LP-11 or LP-111 mode setup are waived
-from calling the two callbacks.
+Receiver drivers that do not need explicit LP-11 or LP-111 state setup are
+waived from calling the two callbacks.
 
 Stopping the transmitter
 ^^^^^^^^^^^^^^^^^^^^^^^^