There are other NXP NCI compatible NFC controllers such as the PN7150
that use an integrated firmware and therefore do not have a GPIO to
select firmware downloading mode. To support this kind of controller,
let's make the firmware GPIO optional.
Signed-off-by: Frieder Schrempf <frieder.schrempf@kontron.de>
Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>
Link: https://lore.kernel.org/r/20201201113921.6572-1-frieder.schrempf@kontron.de
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
 
 - reg: address on the bus
 - interrupts: GPIO interrupt to which the chip is connected
 - enable-gpios: Output GPIO pin used for enabling/disabling the chip
-- firmware-gpios: Output GPIO pin used to enter firmware download mode
 
 Optional SoC Specific Properties:
 - pinctrl-names: Contains only one value - "default".
 - pintctrl-0: Specifies the pin control groups used for this controller.
+- firmware-gpios: Output GPIO pin used to enter firmware download mode
 
 Example (for ARM-based BeagleBone with NPC100 NFC controller on I2C2):
 
 
                return PTR_ERR(phy->gpiod_en);
        }
 
-       phy->gpiod_fw = devm_gpiod_get(dev, "firmware", GPIOD_OUT_LOW);
+       phy->gpiod_fw = devm_gpiod_get_optional(dev, "firmware", GPIOD_OUT_LOW);
        if (IS_ERR(phy->gpiod_fw)) {
                nfc_err(dev, "Failed to get FW gpio\n");
                return PTR_ERR(phy->gpiod_fw);