arm64: dts: qcom: sm8350: fix number of pins in 'gpio-ranges'

The last cell of 'gpio-ranges' should be number of GPIO pins, and in
case of qcom platform it should match msm_pinctrl_soc_data.ngpio rather
than msm_pinctrl_soc_data.ngpio - 1.

This fixes the problem that when the last GPIO pin in the range is
configured with the following call sequence, it always fails with
-EPROBE_DEFER.

    pinctrl_gpio_set_config()
        pinctrl_get_device_gpio_range()
            pinctrl_match_gpio_range()

Fixes: b7e8f433a673 ("arm64: dts: qcom: Add basic devicetree support for SM8350 SoC")
Cc: Vinod Koul <vkoul@kernel.org>
Signed-off-by: Shawn Guo <shawn.guo@linaro.org>
Link: https://lore.kernel.org/r/20210303033106.549-5-shawn.guo@linaro.org
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>

diff --git a/arch/arm64/boot/dts/qcom/sm8350.dtsi b/arch/arm64/boot/dts/qcom/sm8350.dtsi
index 2c02f451379b9d9efa566125e6c6a3721e1e4650..11401ea0c16c10fb9ca0cf12f845b6091b3aa554 100644 (file)
--- a/arch/arm64/boot/dts/qcom/sm8350.dtsi
+++ b/arch/arm64/boot/dts/qcom/sm8350.dtsi
@@ -641,7 +641,7 @@
                        #gpio-cells = <2>;
                        interrupt-controller;
                        #interrupt-cells = <2>;
-                       gpio-ranges = <&tlmm 0 0 203>;
+                       gpio-ranges = <&tlmm 0 0 204>;
 
                        qup_uart3_default_state: qup-uart3-default-state {
                                rx {