ath11k: Identify DFS channel when sending scan channel list command

WMI_CHAN_INFO_DFS flag should be set when configuring a DFS channel
included in scan channel list. Without it, firmware will not send a
probe request frame which is needed in connection to an AP configured
with hidden SSID/network_id. So fix this to allow probe request frames
to be sent in cases where a beacon frame has been seen on the channel
first.

Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-01720.1-QCAHSPSWPL_V1_V2_SILICONZ_LITE-1

Signed-off-by: Baochen Qiang <bqiang@codeaurora.org>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>
Link: https://lore.kernel.org/r/20211011054919.77071-1-bqiang@codeaurora.org

diff --git a/drivers/net/wireless/ath/ath11k/wmi.c b/drivers/net/wireless/ath/ath11k/wmi.c
index 8961c355a81b2418c805b639e1e65fdf1aca755b..5ae2ef4680d6cb59aebded8974d978edea223f68 100644 (file)
--- a/drivers/net/wireless/ath/ath11k/wmi.c
+++ b/drivers/net/wireless/ath/ath11k/wmi.c
@@ -2371,6 +2371,8 @@ int ath11k_wmi_send_scan_chan_list_cmd(struct ath11k *ar,
                                chan_info->info |= WMI_CHAN_INFO_QUARTER_RATE;
                        if (tchan_info->psc_channel)
                                chan_info->info |= WMI_CHAN_INFO_PSC;
+                       if (tchan_info->dfs_set)
+                               chan_info->info |= WMI_CHAN_INFO_DFS;
 
                        chan_info->info |= FIELD_PREP(WMI_CHAN_INFO_MODE,
                                                      tchan_info->phy_mode);