ixgbe: disable tx engine before disabling tx laser

Disabling the tx laser while receiving DMA requests
can hang the device.  After this occurs the device
is in a bad state. The GPIO bit never clears when
PCI master access is disabled and a reboot is required
to get the device in a good state again.

Signed-off-by: John Fastabend <john.r.fastabend@intel.com>
Acked-by: Peter P Waskiewicz Jr <peter.p.waskiewicz.jr@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/ixgbe/ixgbe_main.c b/drivers/net/ixgbe/ixgbe_main.c
index e237748995c19b107eadc6d37e078799a212012d..7ddd60e7d38904ac9d3a87ddad4776b470936fbf 100644 (file)
--- a/drivers/net/ixgbe/ixgbe_main.c
+++ b/drivers/net/ixgbe/ixgbe_main.c
@@ -3684,10 +3684,6 @@ void ixgbe_down(struct ixgbe_adapter *adapter)
        /* signal that we are down to the interrupt handler */
        set_bit(__IXGBE_DOWN, &adapter->state);
 
-       /* power down the optics */
-       if (hw->phy.multispeed_fiber)
-               hw->mac.ops.disable_tx_laser(hw);
-
        /* disable receive for all VFs and wait one second */
        if (adapter->num_vfs) {
                /* ping all the active vfs to let them know we are going down */
@@ -3742,6 +3738,10 @@ void ixgbe_down(struct ixgbe_adapter *adapter)
                                (IXGBE_READ_REG(hw, IXGBE_DMATXCTL) &
                                 ~IXGBE_DMATXCTL_TE));
 
+       /* power down the optics */
+       if (hw->phy.multispeed_fiber)
+               hw->mac.ops.disable_tx_laser(hw);
+
        /* clear n-tuple filters that are cached */
        ethtool_ntuple_flush(netdev);