Revert "ath10k: fix DMA related firmware crashes on multiple devices"

This reverts commit 76d164f582150fd0259ec0fcbc485470bcd8033e.
PCIe hung issue was observed on multiple platforms. The issue was reproduced
when DUT was configured as AP and associated with 50+ STAs.

For QCA9984/QCA9888, the DMA_BURST_SIZE register controls the AXI burst size
of the RD/WR access to the HOST MEM.
0 - No split , RAW read/write transfer size from MAC is put out on bus
    as burst length
1 - Split at 256 byte boundary
2,3 - Reserved

With PCIe protocol analyzer, we can see DMA Read crossing 4KB boundary when
issue happened. It broke PCIe spec and caused PCIe stuck. So revert
the default value from 0 to 1.

Tested:  IPQ8064 + QCA9984 with firmware 10.4-3.10-00047
         QCS404 + QCA9984 with firmware 10.4-3.9.0.2--00044
         Synaptics AS370 + QCA9888  with firmware 10.4-3.9.0.2--00040

Signed-off-by: Zhi Chen <zhichen@codeaurora.org>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

diff --git a/drivers/net/wireless/ath/ath10k/hw.h b/drivers/net/wireless/ath/ath10k/hw.h
index 21b7a2a873b0067b85a074c30f35482d6203b23d..775fd62fb92d79511a7f39ccf53ed50cbe123e50 100644 (file)
--- a/drivers/net/wireless/ath/ath10k/hw.h
+++ b/drivers/net/wireless/ath/ath10k/hw.h
@@ -816,7 +816,7 @@ ath10k_is_rssi_enable(struct ath10k_hw_params *hw,
 
 #define TARGET_10_4_TX_DBG_LOG_SIZE            1024
 #define TARGET_10_4_NUM_WDS_ENTRIES            32
-#define TARGET_10_4_DMA_BURST_SIZE             0
+#define TARGET_10_4_DMA_BURST_SIZE             1
 #define TARGET_10_4_MAC_AGGR_DELIM             0
 #define TARGET_10_4_RX_SKIP_DEFRAG_TIMEOUT_DUP_DETECTION_CHECK 1
 #define TARGET_10_4_VOW_CONFIG                 0