Do not enable/disable pre_tbtt_tasklet tasklet in
mt76x02_sw_scan/mt76x02_sw_scan_complete since it is already done
setting the operating channel. Do run tbtt_tasklet while the device is
offchannel
Signed-off-by: Lorenzo Bianconi <lorenzo@kernel.org>
Signed-off-by: Felix Fietkau <nbd@nbd.name>
        struct sk_buff *skb;
        int i;
 
+       if (mt76_hw(dev)->conf.flags & IEEE80211_CONF_OFFCHANNEL)
+               return;
+
        mt76x02_resync_beacon_timer(dev);
 
        ieee80211_iterate_active_interfaces_atomic(mt76_hw(dev),
 
        if (!dev->mt76.beacon_mask)
                return;
 
+       if (mt76_hw(dev)->conf.flags & IEEE80211_CONF_OFFCHANNEL)
+               return;
+
        mt76x02_resync_beacon_timer(dev);
 
        ieee80211_iterate_active_interfaces(mt76_hw(dev),
 
 {
        struct mt76x02_dev *dev = hw->priv;
 
-       if (mt76_is_mmio(dev))
-               tasklet_disable(&dev->mt76.pre_tbtt_tasklet);
        set_bit(MT76_SCANNING, &dev->mt76.state);
 }
 EXPORT_SYMBOL_GPL(mt76x02_sw_scan);
        struct mt76x02_dev *dev = hw->priv;
 
        clear_bit(MT76_SCANNING, &dev->mt76.state);
-       if (mt76_is_mmio(dev))
-               tasklet_enable(&dev->mt76.pre_tbtt_tasklet);
-
        if (dev->cal.gain_init_done) {
                /* Restore AGC gain and resume calibration after scanning. */
                dev->cal.low_gain = -1;