leds: bcm6328: Swap LED ON and OFF definitions

The values of BCM6328_LED_MODE_ON and BCM6328_LED_MODE_OFF were named
for active low LEDs. These should be swapped so that they are named for
the default case of active high LEDs.

Signed-off-by: Simon Arlott <simon@fire.lp0.eu>
Signed-off-by: Jacek Anaszewski <j.anaszewski@samsung.com>

diff --git a/drivers/leds/leds-bcm6328.c b/drivers/leds/leds-bcm6328.c
index 95d0cf94089b288efaf51580ca0661a5f4af6797..0329dee4687b2b48942e462f625a44fd94660335 100644 (file)
--- a/drivers/leds/leds-bcm6328.c
+++ b/drivers/leds/leds-bcm6328.c
@@ -48,10 +48,10 @@
                                         BCM6328_SERIAL_LED_SHIFT_DIR)
 
 #define BCM6328_LED_MODE_MASK          3
-#define BCM6328_LED_MODE_OFF           0
+#define BCM6328_LED_MODE_ON            0
 #define BCM6328_LED_MODE_FAST          1
 #define BCM6328_LED_MODE_BLINK         2
-#define BCM6328_LED_MODE_ON            3
+#define BCM6328_LED_MODE_OFF           3
 #define BCM6328_LED_SHIFT(X)           ((X) << 1)
 
 /**
@@ -126,9 +126,9 @@ static void bcm6328_led_set(struct led_classdev *led_cdev,
        *(led->blink_leds) &= ~BIT(led->pin);
        if ((led->active_low && value == LED_OFF) ||
            (!led->active_low && value != LED_OFF))
-               bcm6328_led_mode(led, BCM6328_LED_MODE_OFF);
-       else
                bcm6328_led_mode(led, BCM6328_LED_MODE_ON);
+       else
+               bcm6328_led_mode(led, BCM6328_LED_MODE_OFF);
        spin_unlock_irqrestore(led->lock, flags);
 }
 
@@ -303,8 +303,8 @@ static int bcm6328_led(struct device *dev, struct device_node *nc, u32 reg,
                        val = bcm6328_led_read(mode) >>
                              BCM6328_LED_SHIFT(shift % 16);
                        val &= BCM6328_LED_MODE_MASK;
-                       if ((led->active_low && val == BCM6328_LED_MODE_ON) ||
-                           (!led->active_low && val == BCM6328_LED_MODE_OFF))
+                       if ((led->active_low && val == BCM6328_LED_MODE_OFF) ||
+                           (!led->active_low && val == BCM6328_LED_MODE_ON))
                                led->cdev.brightness = LED_FULL;
                        else
                                led->cdev.brightness = LED_OFF;