There are a few leading spaces before tabs and remove it by running
the following commard:
	$ find . -name '*.[ch]' | xargs sed -r -i 's/^[ ]+\t/\t/'
Cc: Xie He <xie.he.0141@gmail.com>
Signed-off-by: Hui Tang <tanghui20@huawei.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
  */
 int lmc_probe(struct net_device * dev);
 unsigned lmc_mii_readreg(lmc_softc_t * const sc, unsigned
-                         devaddr, unsigned regno);
+                         devaddr, unsigned regno);
 void lmc_mii_writereg(lmc_softc_t * const sc, unsigned devaddr,
                               unsigned regno, unsigned data);
 void lmc_led_on(lmc_softc_t * const, u32);
 
        card->plx = ioremap(plx_phy, 0x70);
        if (!card->plx) {
                pr_err("ioremap() failed\n");
-               wanxl_pci_remove_one(pdev);
+               wanxl_pci_remove_one(pdev);
                return -EFAULT;
        }
 
        mem = ioremap(mem_phy, PDM_OFFSET + sizeof(firmware));
        if (!mem) {
                pr_err("ioremap() failed\n");
-               wanxl_pci_remove_one(pdev);
+               wanxl_pci_remove_one(pdev);
                return -EFAULT;
        }
 
 
        z8530_rx_done(c);
        z8530_rx_done(c);
 
-       /*
+       /*
         *      Load the DMA interfaces up
         */
 
        c->dma_ready=1;
        c->dma_tx = 1;
 
-       /*
+       /*
         *      Enable DMA control mode
         */
 
-       /*
+       /*
         *      TX DMA via DIR/REQ
-        */
+        */
        c->regs[R14]|= DTRREQ;
        write_zsreg(c, R14, c->regs[R14]);