pinconf-generic: fix style issues in pin_config_param doc

Fixes following issues introduced in a  previous commit
to clarify values for pin config pull up and down types.

- replace spaces with tabs to be consistent with rest of the doc
- use capitalization for unit (ohms -> Ohms)

Signed-off-by: Niyas Sait <niyas.sait@linaro.org>
Reviewed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Link: https://lore.kernel.org/r/20221117123542.1154252-1-niyas.sait@linaro.org
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

diff --git a/include/linux/pinctrl/pinconf-generic.h b/include/linux/pinctrl/pinconf-generic.h
index c9c10142657e82240b71e2ff7fedb7c6e0350865..d74b7a4ea154dec659e7ebf7a48d8824203963a9 100644 (file)
--- a/include/linux/pinctrl/pinconf-generic.h
+++ b/include/linux/pinctrl/pinconf-generic.h
@@ -39,7 +39,7 @@ struct pinctrl_map;
  * @PIN_CONFIG_BIAS_PULL_DOWN: the pin will be pulled down (usually with high
  *     impedance to GROUND). If the argument is != 0 pull-down is enabled,
  *     the value is interpreted by the driver and can be custom or an SI unit
- *  such as ohms.
+ *     such as Ohms.
  * @PIN_CONFIG_BIAS_PULL_PIN_DEFAULT: the pin will be pulled up or down based
  *     on embedded knowledge of the controller hardware, like current mux
  *     function. The pull direction and possibly strength too will normally
@@ -51,7 +51,7 @@ struct pinctrl_map;
  * @PIN_CONFIG_BIAS_PULL_UP: the pin will be pulled up (usually with high
  *     impedance to VDD). If the argument is != 0 pull-up is enabled,
  *     the value is interpreted by the driver and can be custom or an SI unit
- *  such as ohms.
+ *     such as Ohms.
  * @PIN_CONFIG_DRIVE_OPEN_DRAIN: the pin will be driven with open drain (open
  *     collector) which means it is usually wired with other output ports
  *     which are then pulled up with an external resistor. Setting this