Since the plane_state variable is declared outside the scaler_users
loop in intel_atomic_setup_scalers(), and it's never reset back to
NULL inside the loop we may end up calling intel_atomic_setup_scaler()
with a non-NULL plane state for the pipe scaling case. That is bad
because intel_atomic_setup_scaler() determines whether we are doing
plane scaling or pipe scaling based on plane_state!=NULL. The end
result is that we may miscalculate the scaler mode for pipe scaling.
The hardware becomes somewhat upset if we end up in this situation
when scanning out a planar format on a SDR plane. We end up
programming the pipe scaler into planar mode as well, and the
result is a screenfull of garbage.
Fix the situation by making sure we pass the correct plane_state==NULL
when calculating the scaler mode for pipe scaling.
Cc: stable@vger.kernel.org
Signed-off-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20231207193441.20206-2-ville.syrjala@linux.intel.com
Reviewed-by: Jani Nikula <jani.nikula@intel.com>
{
struct drm_plane *plane = NULL;
struct intel_plane *intel_plane;
- struct intel_plane_state *plane_state = NULL;
struct intel_crtc_scaler_state *scaler_state =
&crtc_state->scaler_state;
struct drm_atomic_state *drm_state = crtc_state->uapi.state;
/* walkthrough scaler_users bits and start assigning scalers */
for (i = 0; i < sizeof(scaler_state->scaler_users) * 8; i++) {
+ struct intel_plane_state *plane_state = NULL;
int *scaler_id;
const char *name;
int idx, ret;