esp.c: remove unneeded if() check in esp_transfer_data()

The following ti_cmd checks ensure that only DMA and non-DMA TI commmands will
can call into the esp_do_dma() and esp_do_nodma() callbacks.

Signed-off-by: Mark Cave-Ayland <mark.cave-ayland@ilande.co.uk>
Tested-by: Helge Deller <deller@gmx.de>
Tested-by: Thomas Huth <thuth@redhat.com>
Message-Id: <20240112125420.514425-27-mark.cave-ayland@ilande.co.uk>
Signed-off-by: Mark Cave-Ayland <mark.cave-ayland@ilande.co.uk>

diff --git a/hw/scsi/esp.c b/hw/scsi/esp.c
index 3db90c9ab73f8bb7d06475bbeeb402efdadb7179..96123c5f7db002f3ccc7e8124b989c7ebf519b7d 100644 (file)
--- a/hw/scsi/esp.c
+++ b/hw/scsi/esp.c
@@ -916,16 +916,13 @@ void esp_transfer_data(SCSIRequest *req, uint32_t len)
         esp_raise_irq(s);
     }
 
-    if (s->ti_cmd == 0) {
-        /*
-         * Always perform the initial transfer upon reception of the next TI
-         * command to ensure the DMA/non-DMA status of the command is correct.
-         * It is not possible to use s->dma directly in the section below as
-         * some OSs send non-DMA NOP commands after a DMA transfer. Hence if the
-         * async data transfer is delayed then s->dma is set incorrectly.
-         */
-        return;
-    }
+    /*
+     * Always perform the initial transfer upon reception of the next TI
+     * command to ensure the DMA/non-DMA status of the command is correct.
+     * It is not possible to use s->dma directly in the section below as
+     * some OSs send non-DMA NOP commands after a DMA transfer. Hence if the
+     * async data transfer is delayed then s->dma is set incorrectly.
+     */
 
     if (s->ti_cmd == (CMD_TI | CMD_DMA)) {
         if (dmalen) {