From: Biju Das Date: Wed, 12 Apr 2023 14:50:51 +0000 (+0100) Subject: tty: serial: sh-sci: Fix TE setting on SCI IP X-Git-Url: http://git.maquefel.me/?a=commitdiff_plain;h=1707ce2d1e4d701db28ba2250d9d72dcf762babc;p=linux.git tty: serial: sh-sci: Fix TE setting on SCI IP As per the RZ/G2L users hardware manual (Rev.1.20 Sep, 2022), section 23.3.7 Serial Data Transmission (Asynchronous Mode) it is mentioned that the TE (transmit enable) must be set after setting TIE (transmit interrupt enable) or these 2 bits are set to 1 simultaneously by a single instruction. So set these 2 bits in single instruction. Signed-off-by: Biju Das Link: https://lore.kernel.org/r/20230412145053.114847-4-biju.das.jz@bp.renesas.com Signed-off-by: Greg Kroah-Hartman --- diff --git a/drivers/tty/serial/sh-sci.c b/drivers/tty/serial/sh-sci.c index 15743c2f3d3d5..32f5c1f7d697a 100644 --- a/drivers/tty/serial/sh-sci.c +++ b/drivers/tty/serial/sh-sci.c @@ -601,6 +601,15 @@ static void sci_start_tx(struct uart_port *port) port->type == PORT_SCIFA || port->type == PORT_SCIFB) { /* Set TIE (Transmit Interrupt Enable) bit in SCSCR */ ctrl = serial_port_in(port, SCSCR); + + /* + * For SCI, TE (transmit enable) must be set after setting TIE + * (transmit interrupt enable) or in the same instruction to start + * the transmit process. + */ + if (port->type == PORT_SCI) + ctrl |= SCSCR_TE; + serial_port_out(port, SCSCR, ctrl | SCSCR_TIE); } } @@ -2600,8 +2609,14 @@ done: sci_set_mctrl(port, port->mctrl); } - scr_val |= SCSCR_RE | SCSCR_TE | - (s->cfg->scscr & ~(SCSCR_CKE1 | SCSCR_CKE0)); + /* + * For SCI, TE (transmit enable) must be set after setting TIE + * (transmit interrupt enable) or in the same instruction to + * start the transmitting process. So skip setting TE here for SCI. + */ + if (port->type != PORT_SCI) + scr_val |= SCSCR_TE; + scr_val |= SCSCR_RE | (s->cfg->scscr & ~(SCSCR_CKE1 | SCSCR_CKE0)); serial_port_out(port, SCSCR, scr_val | s->hscif_tot); if ((srr + 1 == 5) && (port->type == PORT_SCIFA || port->type == PORT_SCIFB)) {