From: Tim Harvey <tharvey@gateworks.com>
Date: Mon, 28 Aug 2023 19:26:15 +0000 (-0700)
Subject: ARM: dts: imx6qdl-gw5904: add internal mdio nodes
X-Git-Url: http://git.maquefel.me/?a=commitdiff_plain;h=2af439120257583191ba20c0d055054447b01271;p=linux.git

ARM: dts: imx6qdl-gw5904: add internal mdio nodes

Complete the switch definition by adding the internal mdio nodes.

This does not change behavior on Linux but is required if the dt is used
for U-Boot which requires the internal PHY ports to be defined for
DSA.

Signed-off-by: Tim Harvey <tharvey@gateworks.com>
Reviewed-by: Vladimir Oltean <vladimir.oltean@nxp.com>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
---

diff --git a/arch/arm/boot/dts/nxp/imx/imx6qdl-gw5904.dtsi b/arch/arm/boot/dts/nxp/imx/imx6qdl-gw5904.dtsi
index 9594bc5745ed6..3375b3fd8d4cc 100644
--- a/arch/arm/boot/dts/nxp/imx/imx6qdl-gw5904.dtsi
+++ b/arch/arm/boot/dts/nxp/imx/imx6qdl-gw5904.dtsi
@@ -212,6 +212,27 @@
 			compatible = "marvell,mv88e6085";
 			reg = <0>;
 
+			mdio {
+				#address-cells = <1>;
+				#size-cells = <0>;
+
+				sw_phy0: ethernet-phy@0 {
+					reg = <0x0>;
+				};
+
+				sw_phy1: ethernet-phy@1 {
+					reg = <0x1>;
+				};
+
+				sw_phy2: ethernet-phy@2 {
+					reg = <0x2>;
+				};
+
+				sw_phy3: ethernet-phy@3 {
+					reg = <0x3>;
+				};
+			};
+
 			ports {
 				#address-cells = <1>;
 				#size-cells = <0>;
@@ -219,21 +240,29 @@
 				port@0 {
 					reg = <0>;
 					label = "lan4";
+					phy-handle = <&sw_phy0>;
+					phy-mode = "internal";
 				};
 
 				port@1 {
 					reg = <1>;
 					label = "lan3";
+					phy-handle = <&sw_phy1>;
+					phy-mode = "internal";
 				};
 
 				port@2 {
 					reg = <2>;
 					label = "lan2";
+					phy-handle = <&sw_phy2>;
+					phy-mode = "internal";
 				};
 
 				port@3 {
 					reg = <3>;
 					label = "lan1";
+					phy-handle = <&sw_phy3>;
+					phy-mode = "internal";
 				};
 
 				port@5 {