From: Guangbin Huang Date: Wed, 19 Feb 2020 01:23:30 +0000 (+0800) Subject: net: hns3: modify an unsuitable print when setting unknown duplex to fibre X-Git-Url: http://git.maquefel.me/?a=commitdiff_plain;h=2d3db26d78805c9e06e26def0081c76e9bb0b7d6;p=linux.git net: hns3: modify an unsuitable print when setting unknown duplex to fibre Currently, if device is in link down status and user uses 'ethtool -s' command to set speed but not specify duplex mode, the duplex mode passed from ethtool to driver is unknown value(255), and the fibre port will identify this value as half duplex mode and print "only copper port supports half duplex!". This message is confusing. So for fibre port, only the setting duplex is half, prints error and returns. Signed-off-by: Guangbin Huang Signed-off-by: Huazhong Tan Signed-off-by: David S. Miller --- diff --git a/drivers/net/ethernet/hisilicon/hns3/hns3_ethtool.c b/drivers/net/ethernet/hisilicon/hns3/hns3_ethtool.c index c03856e633202..3f59a1924390f 100644 --- a/drivers/net/ethernet/hisilicon/hns3/hns3_ethtool.c +++ b/drivers/net/ethernet/hisilicon/hns3/hns3_ethtool.c @@ -736,7 +736,7 @@ static int hns3_check_ksettings_param(const struct net_device *netdev, if (ops->get_media_type) ops->get_media_type(handle, &media_type, &module_type); - if (cmd->base.duplex != DUPLEX_FULL && + if (cmd->base.duplex == DUPLEX_HALF && media_type != HNAE3_MEDIA_TYPE_COPPER) { netdev_err(netdev, "only copper port supports half duplex!");