From: Wan Ahmad Zainie Date: Tue, 7 Apr 2020 13:34:39 +0000 (+0800) Subject: i2c: designware: Calculate SCL timing parameter for High Speed Mode X-Git-Url: http://git.maquefel.me/?a=commitdiff_plain;h=35eba185fd1a3c61556a3050edbddc58d953303f;p=linux.git i2c: designware: Calculate SCL timing parameter for High Speed Mode Custom parameters for HCNT/LCNT are not available for OF based system. Thus, we will use existing SCL timing parameter calculation functions for High Speed Mode too. The value for the parameters tSYMBOL and tLOW is taken from DesignWare DW_apb_i2c Databook v2.01a, section 3.15.4.6. The calculation should assume higher bus load since it gives slower timing parameter. Signed-off-by: Wan Ahmad Zainie Reviewed-by: Andy Shevchenko Acked-by: Jarkko Nikula Signed-off-by: Wolfram Sang --- diff --git a/drivers/i2c/busses/i2c-designware-master.c b/drivers/i2c/busses/i2c-designware-master.c index 23038d7272da3..b6c17b550d31e 100644 --- a/drivers/i2c/busses/i2c-designware-master.c +++ b/drivers/i2c/busses/i2c-designware-master.c @@ -129,10 +129,22 @@ static int i2c_dw_set_timings_master(struct dw_i2c_dev *dev) dev->master_cfg |= DW_IC_CON_SPEED_FAST; dev->hs_hcnt = 0; dev->hs_lcnt = 0; - } else if (dev->hs_hcnt && dev->hs_lcnt) { - dev_dbg(dev->dev, "High Speed Mode HCNT:LCNT = %d:%d\n", - dev->hs_hcnt, dev->hs_lcnt); + } else if (!dev->hs_hcnt || !dev->hs_lcnt) { + ic_clk = i2c_dw_clk_rate(dev); + dev->hs_hcnt = + i2c_dw_scl_hcnt(ic_clk, + 160, /* tHIGH = 160 ns */ + sda_falling_time, + 0, /* DW default */ + 0); /* No offset */ + dev->hs_lcnt = + i2c_dw_scl_lcnt(ic_clk, + 320, /* tLOW = 320 ns */ + scl_falling_time, + 0); /* No offset */ } + dev_dbg(dev->dev, "High Speed Mode HCNT:LCNT = %d:%d\n", + dev->hs_hcnt, dev->hs_lcnt); } ret = i2c_dw_set_sda_hold(dev);