From: Varshini Rajendran Date: Fri, 23 Feb 2024 17:25:31 +0000 (+0530) Subject: dt-bindings: pinctrl: at91: add sam9x7 X-Git-Url: http://git.maquefel.me/?a=commitdiff_plain;h=577293d391da30427fa193e7c4b290db1b0b9a3a;p=linux.git dt-bindings: pinctrl: at91: add sam9x7 Add device tree binding for SAM9X7 pin controller. Signed-off-by: Varshini Rajendran Acked-by: Krzysztof Kozlowski Link: https://lore.kernel.org/r/20240223172531.671993-1-varshini.rajendran@microchip.com Signed-off-by: Linus Walleij --- diff --git a/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt b/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt index e8abbdad7b5da..0aa1a53012d6c 100644 --- a/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt +++ b/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt @@ -20,6 +20,7 @@ such as pull-up, multi drive, etc. Required properties for iomux controller: - compatible: "atmel,at91rm9200-pinctrl" or "atmel,at91sam9x5-pinctrl" or "atmel,sama5d3-pinctrl" or "microchip,sam9x60-pinctrl" + or "microchip,sam9x7-pinctrl", "microchip,sam9x60-pinctrl" - atmel,mux-mask: array of mask (periph per bank) to describe if a pin can be configured in this periph mode. All the periph and bank need to be describe. @@ -120,6 +121,7 @@ Some requirements for using atmel,at91rm9200-pinctrl binding: For each bank the required properties are: - compatible: "atmel,at91sam9x5-gpio" or "atmel,at91rm9200-gpio" or "microchip,sam9x60-gpio" + or "microchip,sam9x7-gpio", "microchip,sam9x60-gpio", "atmel,at91rm9200-gpio" - reg: physical base address and length of the controller's registers - interrupts: interrupt outputs from the controller - interrupt-controller: marks the device node as an interrupt controller