From: Jon Hunter Date: Fri, 28 Oct 2022 12:33:56 +0000 (+0100) Subject: pwm: tegra: Ensure the clock rate is not less than needed X-Git-Url: http://git.maquefel.me/?a=commitdiff_plain;h=5eccd0d9fabc4d2ab8d2a0c056fb1d7e2ff892fc;p=linux.git pwm: tegra: Ensure the clock rate is not less than needed When dynamically scaling the PWM clock, the function dev_pm_opp_set_rate() may set the PWM clock to a rate that is lower than what is required. The clock rate requested when calling dev_pm_opp_set_rate() is the minimum clock rate that is needed to drive the PWM to achieve the required period. Hence, if the actual clock rate is less than the requested clock rate, then the required period cannot be achieved and configuring the PWM fails. Fix this by calling clk_round_rate() to check if the clock rate that will be provided is sufficient and if not, double the required clock rate to ensure the required period can be attained. Fixes: 8c193f4714df ("pwm: tegra: Optimize period calculation") Signed-off-by: Jon Hunter Acked-by: Uwe Kleine-König Signed-off-by: Thierry Reding --- diff --git a/drivers/pwm/pwm-tegra.c b/drivers/pwm/pwm-tegra.c index b05ea2e8acccb..6fc4b69a3ba71 100644 --- a/drivers/pwm/pwm-tegra.c +++ b/drivers/pwm/pwm-tegra.c @@ -148,6 +148,17 @@ static int tegra_pwm_config(struct pwm_chip *chip, struct pwm_device *pwm, required_clk_rate = DIV_ROUND_UP_ULL(NSEC_PER_SEC << PWM_DUTY_WIDTH, period_ns); + if (required_clk_rate > clk_round_rate(pc->clk, required_clk_rate)) + /* + * required_clk_rate is a lower bound for the input + * rate; for lower rates there is no value for PWM_SCALE + * that yields a period less than or equal to the + * requested period. Hence, for lower rates, double the + * required_clk_rate to get a clock rate that can meet + * the requested period. + */ + required_clk_rate *= 2; + err = dev_pm_opp_set_rate(pc->dev, required_clk_rate); if (err < 0) return -EINVAL;