From: Venkata Lakshmi Narayana Gubba Date: Thu, 11 Mar 2021 07:03:40 +0000 (+0530) Subject: Bluetooth: hci_qca: Add device_may_wakeup support X-Git-Url: http://git.maquefel.me/?a=commitdiff_plain;h=c1a74160eaf1ac218733b371158432b52601beff;p=linux.git Bluetooth: hci_qca: Add device_may_wakeup support Based on device may wakeup status, Bluez stack will enable/disable passive scanning with whitelist in BT controller while suspending. As interrupt from BT SoC is handled by UART driver,we need to use device handle of UART driver to get the status of device may wakeup Signed-off-by: Venkata Lakshmi Narayana Gubba Signed-off-by: Marcel Holtmann --- diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c index de36af63e1825..73af901c2032b 100644 --- a/drivers/bluetooth/hci_qca.c +++ b/drivers/bluetooth/hci_qca.c @@ -1571,6 +1571,20 @@ static void qca_cmd_timeout(struct hci_dev *hdev) mutex_unlock(&qca->hci_memdump_lock); } +static bool qca_prevent_wake(struct hci_dev *hdev) +{ + struct hci_uart *hu = hci_get_drvdata(hdev); + bool wakeup; + + /* UART driver handles the interrupt from BT SoC.So we need to use + * device handle of UART driver to get the status of device may wakeup. + */ + wakeup = device_may_wakeup(hu->serdev->ctrl->dev.parent); + bt_dev_dbg(hu->hdev, "wakeup status : %d", wakeup); + + return !wakeup; +} + static int qca_wcn3990_init(struct hci_uart *hu) { struct qca_serdev *qcadev; @@ -1721,6 +1735,7 @@ retry: qca_debugfs_init(hdev); hu->hdev->hw_error = qca_hw_error; hu->hdev->cmd_timeout = qca_cmd_timeout; + hu->hdev->prevent_wake = qca_prevent_wake; } else if (ret == -ENOENT) { /* No patch/nvm-config found, run with original fw/config */ set_bit(QCA_ROM_FW, &qca->flags);