From: Wolfram Sang Date: Tue, 10 Nov 2020 14:20:57 +0000 (+0100) Subject: mmc: renesas_sdhi: populate SCC pointer at the proper place X-Git-Url: http://git.maquefel.me/?a=commitdiff_plain;h=d14ac691bb6f6ebaa7eeec21ca04dd47300ff5b6;p=linux.git mmc: renesas_sdhi: populate SCC pointer at the proper place The SCC pointer is currently filled whenever the SoC is Gen2+. This is wrong because there is a Gen2-variant without SCC (SDHI_VER_GEN2_SDR50). We have been lucky because the writes to unintended registers have not caused problems so far. But further refactoring work exposed the problem. So, move the pointer initialization to the place where we know that the SDHI instance supports tuning. And also populate the 'reset' pointer unconditionally to make sure the interrupt enable register is always properly set for Gen2+. Signed-off-by: Wolfram Sang Reviewed-by: Niklas Söderlund Reviewed-by: Yoshihiro Shimoda Tested-by: Yoshihiro Shimoda Link: https://lore.kernel.org/r/20201110142058.36393-4-wsa+renesas@sang-engineering.com Signed-off-by: Ulf Hansson --- diff --git a/drivers/mmc/host/renesas_sdhi_core.c b/drivers/mmc/host/renesas_sdhi_core.c index 17ebaa324ca1e..4a1ed5bf216c6 100644 --- a/drivers/mmc/host/renesas_sdhi_core.c +++ b/drivers/mmc/host/renesas_sdhi_core.c @@ -1007,11 +1007,7 @@ int renesas_sdhi_probe(struct platform_device *pdev, host->ops.start_signal_voltage_switch = renesas_sdhi_start_signal_voltage_switch; host->sdcard_irq_setbit_mask = TMIO_STAT_ALWAYS_SET_27; - - if (of_data && of_data->scc_offset) { - priv->scc_ctl = host->ctl + of_data->scc_offset; - host->reset = renesas_sdhi_reset; - } + host->reset = renesas_sdhi_reset; } /* Orginally registers were 16 bit apart, could be 32 or 64 nowadays */ @@ -1091,6 +1087,7 @@ int renesas_sdhi_probe(struct platform_device *pdev, if (!hit) dev_warn(&host->pdev->dev, "Unknown clock rate for tuning\n"); + priv->scc_ctl = host->ctl + of_data->scc_offset; host->check_retune = renesas_sdhi_check_scc_error; host->ops.execute_tuning = renesas_sdhi_execute_tuning; host->ops.prepare_hs400_tuning = renesas_sdhi_prepare_hs400_tuning;