From: Kang Yang Date: Fri, 1 Dec 2023 16:09:48 +0000 (+0200) Subject: wifi: ath12k: fix and enable AP mode for WCN7850 X-Git-Url: http://git.maquefel.me/?a=commitdiff_plain;h=ed7e818a7b501012038d6bc6fedadaf7375a380a;p=linux.git wifi: ath12k: fix and enable AP mode for WCN7850 For AP mode, the peer is created earlier in ath12k_mac_op_add_interface() but ath12k_mac_op_assign_vif_chanctx() will try to create peer again. Then an error will return which makes AP mode startup fail. Kernel log: [ 5017.665006] ath12k_pci 0000:04:00.0: failed to create peer after vdev start delay: -22 wpa_supplicant log: Failed to set beacon parameters Interface initialization failed wls1: interface state UNINITIALIZED->DISABLED wls1: AP-DISABLED wls1: Unable to setup interface. Failed to initialize AP interface wls1: interface state DISABLED->DISABLED wls1: AP-DISABLED So fix this check and enable AP mode for WCN7850, as now AP mode works normally. Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0-03427-QCAHMTSWPL_V1.0_V2.0_SILICONZ-1.15378.4 Signed-off-by: Kang Yang Acked-by: Jeff Johnson Signed-off-by: Kalle Valo Link: https://lore.kernel.org/r/20231121022459.17209-1-quic_kangyang@quicinc.com --- diff --git a/drivers/net/wireless/ath/ath12k/hw.c b/drivers/net/wireless/ath/ath12k/hw.c index ea3eda1f19489..de60d988d8608 100644 --- a/drivers/net/wireless/ath/ath12k/hw.c +++ b/drivers/net/wireless/ath/ath12k/hw.c @@ -949,7 +949,8 @@ static const struct ath12k_hw_params ath12k_hw_params[] = { .rx_mac_buf_ring = true, .vdev_start_delay = true, - .interface_modes = BIT(NL80211_IFTYPE_STATION), + .interface_modes = BIT(NL80211_IFTYPE_STATION) | + BIT(NL80211_IFTYPE_AP), .supports_monitor = false, .idle_ps = true, diff --git a/drivers/net/wireless/ath/ath12k/mac.c b/drivers/net/wireless/ath/ath12k/mac.c index 556013f8c6096..a27135436f412 100644 --- a/drivers/net/wireless/ath/ath12k/mac.c +++ b/drivers/net/wireless/ath/ath12k/mac.c @@ -6389,8 +6389,8 @@ ath12k_mac_op_assign_vif_chanctx(struct ieee80211_hw *hw, } if (ab->hw_params->vdev_start_delay && - (arvif->vdev_type == WMI_VDEV_TYPE_AP || - arvif->vdev_type == WMI_VDEV_TYPE_MONITOR)) { + arvif->vdev_type != WMI_VDEV_TYPE_AP && + arvif->vdev_type != WMI_VDEV_TYPE_MONITOR) { param.vdev_id = arvif->vdev_id; param.peer_type = WMI_PEER_TYPE_DEFAULT; param.peer_addr = ar->mac_addr;