From 7bb9b9e34b8742afc0cd8547103ef0106012947b Mon Sep 17 00:00:00 2001 From: David Jander Date: Mon, 21 Feb 2022 10:53:12 +0100 Subject: [PATCH] ARM: dts: imx6qdl-victgo: add CAN termination support The gpio1 0 pin is controlling CAN termination, not USB H1 VBUS. So, remove wrong regulator and assign this gpio to new DT CAN termination property. Signed-off-by: David Jander Signed-off-by: Oleksij Rempel Signed-off-by: Shawn Guo --- arch/arm/boot/dts/imx6dl-victgo.dts | 12 ++---------- 1 file changed, 2 insertions(+), 10 deletions(-) diff --git a/arch/arm/boot/dts/imx6dl-victgo.dts b/arch/arm/boot/dts/imx6dl-victgo.dts index 7a29283da2451..7dd7fb1654320 100644 --- a/arch/arm/boot/dts/imx6dl-victgo.dts +++ b/arch/arm/boot/dts/imx6dl-victgo.dts @@ -160,15 +160,6 @@ regulator-max-microvolt = <3300000>; }; - reg_h1_vbus: regulator-h1-vbus { - compatible = "regulator-fixed"; - regulator-name = "h1-vbus"; - regulator-min-microvolt = <5000000>; - regulator-max-microvolt = <5000000>; - gpio = <&gpio1 0 GPIO_ACTIVE_HIGH>; - enable-active-high; - }; - reg_otg_vbus: regulator-otg-vbus { compatible = "regulator-fixed"; regulator-name = "otg-vbus"; @@ -312,6 +303,8 @@ &can1 { pinctrl-names = "default"; pinctrl-0 = <&pinctrl_can1>; + termination-gpios = <&gpio1 0 GPIO_ACTIVE_LOW>; + termination-ohms = <150>; status = "okay"; }; @@ -648,7 +641,6 @@ }; &usbh1 { - vbus-supply = <®_h1_vbus>; pinctrl-names = "default"; phy_type = "utmi"; dr_mode = "host"; -- 2.30.2