From be8be0d036b2fed1f705931ac3901077039b7496 Mon Sep 17 00:00:00 2001 From: Vaishnav Achath Date: Sat, 13 May 2023 18:03:12 +0530 Subject: [PATCH] arm64: dts: ti: k3-j7200-common-proc-board: Add OSPI/Hyperflash select pinmux J7200 common processor board has an onboard mux for selecting whether the OSPI signals are externally routed to OSPI flash or Hyperflash. The mux state signal input is tied to WKUP_GPIO0_6 and is used by bootloader for enabling the corresponding node accordingly. Add pinmux for the same. Signed-off-by: Vaishnav Achath Link: https://lore.kernel.org/r/20230513123313.11462-4-vaishnav.a@ti.com Signed-off-by: Vignesh Raghavendra --- arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts | 11 +++++++++++ 1 file changed, 11 insertions(+) diff --git a/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts index 0cc0e1dc40c54..e1017027d6499 100644 --- a/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts +++ b/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts @@ -97,6 +97,12 @@ >; }; + wkup_gpio_pins_default: wkup-gpio-pins-default { + pinctrl-single,pins = < + J721E_WKUP_IOPAD(0x70, PIN_INPUT, 7) /* (C14) WKUP_GPIO0_6 */ + >; + }; + mcu_mdio_pins_default: mcu-mdio1-pins-default { pinctrl-single,pins = < J721E_WKUP_IOPAD(0x0034, PIN_OUTPUT, 0) /* (L1) MCU_MDIO0_MDC */ @@ -186,6 +192,11 @@ status = "disabled"; }; +&wkup_gpio0 { + pinctrl-names = "default"; + pinctrl-0 = <&wkup_gpio_pins_default>; +}; + &wkup_gpio1 { status = "disabled"; }; -- 2.30.2